Because of all the rain up here on the west coast lately, (yes, it's still raining though it's summer):cryin:, I wan't to get some fenders for my roadbike. But there's only like a half an inch of clearance between the tire and the brake calliper. :mad2:

So are there any fenders that would work with that set-up? or maybe if I bought some different brakes that had more clearance it would work.:idea: Right now I've got Cane Creek 3 brakes on, and the tires are 25's. The bike is a Trek 2100.

thanks!

River City Bicycles in Portland makes these Reacharounds (http://www.rivercitybicycles.com/mod.php?mod=userpage&menu=1105&page_id=58) which should allow you to split any fender for tight-clearance mounting.

Because of all the rain up here on the west coast lately, (yes, it's still raining though it's summer):cryin:, I wan't to get some fenders for my roadbike. But there's only like a half an inch of clearance between the tire and the brake calliper. :mad2:

So are there any fenders that would work with that set-up? or maybe if I bought some different brakes that had more clearance it would work.:idea: Right now I've got Cane Creek 3 brakes on, and the tires are 25's. The bike is a Trek 2100.

thanks!

Actually, 1/2" is a fair bit. A few thoughts.

1. I'd look for somewhat more "curved" fenders (in cross-section) so that you get decent covereage on the sides. I'm running stainless Berthouds.

2. Different brakes probably won't help much with clearance--in most cases, it's a matter of the fork and the brake bridge rather than the stoppers.

3. The rear could be a problem--most fenders attach to the brake bolt with a tab that holds the fenders a little low. But if you're willing to drill a couple of holes, you can use a cable tie to pull the fender right up against the brake bridge, and that makes a huge difference. In theory, you could do the same in front, using the brake bolt at the bottom of the steerer as a lashing point, but it might be difficult to do. A little bit of thing rubber shim at the contact points will reduce noise.

BTW, if you don't have frame/fork eyelets for the fender stays, P-clips work pretty well.

I once put fenders on a road bike with < 1/4" clearance, so I know if can be done...it was a real pain, but it worked!

I cut some plastic fenders down to fit on one of my bikes - sounds like there's plenty of room - use some zip ties to hold it all together

I cut some plastic fenders down to fit on one of my bikes - sounds like there's plenty of room - use some zip ties to hold it all together

I know at work there's an SKS fender designed for road bikes without fender mounts. Straps onto the chain stay but give minimal coverage- better than none IMO.

yep, SKS Race Blades. They work decently.

yep, SKS Race Blades. They work decently.
I just bought a pair of these and they work great. Your back won't get that dirt line up the back and water doesn't soak your shoes when you turn the wheel. Not to mention they go on and off in a flash. Well worth the $25 I paid on ebay.