Building up a Fierte Ti and had a few questions about where I need anti-seize and where regular grease is sufficient.

1. Are the braze-ons for the bottle cages made of alu? If so, just regular grease, right?

2. Rear derailleur hangar - Ti or alu?

3. Seatpost clamp - Ti or alu?

4. Threaded braze-on (not sure what these are called) on the headtube into which the barrel adjuster screws in - Ti or alu?

5. Front derailleur band clamp - should I use anti-seize or grease here before mounting to seat tube?

6. Insert in the seat tube for the seatpost is alu, right? So regular grease is fine?

TIA.

Ask Serotta or go to the Serotta website and ask on the forum.

Building up a Fierte Ti and had a few questions about where I need anti-seize and where regular grease is sufficient.

1. Are the braze-ons for the bottle cages made of alu? If so, just regular grease, right? Regular grease

2. Rear derailleur hangar - Ti or alu? Anti-seize
3. Seatpost clamp - Ti or alu? Regular grease

4. Threaded braze-on (not sure what these are called) on the headtube into which the barrel adjuster screws in - Ti or alu? Regular grease

5. Front derailleur band clamp - should I use anti-seize or grease here before mounting to seat tube? Very light coating of regular grease
6. Insert in the seat tube for the seatpost is alu, right? So regular grease is fine? Regular grease
TIA.

Regular grease means lithium grease though I use Phil waterproof grease because it smells like grease should.