Hello all,

I just treated myself to some FSA Kwings (income tax return!) Being the instant gratification type and having a desire to do my own work, I decided to install them myself. The project went okay, aside from it turning into more than just a bar swap. After it was all said and done, I ended up repacking the headset, replacing all the cables and housings and cursing my internal cable routing. Which finally brings me to my question, How do you apply the bar tape to these so it looks good? I stopped right at the bend before the Wide "ergo" section, it looks like hell. So if any of you could shed some light on this for me I would greatly appreciate it.

Thanks!!