Road Bike, Cycling Forums banner

Post your custom road bike specifications here.

1K views 3 replies 4 participants last post by  halldavid328888 
#1 ·
Hi Guys / Girls,

I am currently building a road bike and I am really interested in anyone ones else's breakdown, build specification, supplier, cost and photographs.

Regards, geebo
 
#3 ·
Before getting crashed out earlier this season I had a custom Tsunami.

The primary measurements I was concerned about are listed below, the rest I left up to the builder:

TT: 57 cm
STA: 74 degrees
HT: 11.4 cm (total stack height of 14.5 cm with an external headset.

I also wanted a lot of slope to the top tube for stand-over clearance.

With this bike I had 170 mm cranks, 10 cm -10 degree Thompson stem, 0 degree Thompson seat post. The fit was excellent and at some point in time in the future I'll get another custom frame with similar measurements. I love my Cannondale CAAD10 frame, but it just doesn't fit quite as well as my custom Tsunami did.

 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top