Joined
·
0 Posts
Morning dave
I recently brought a ritchey wcs c260, its a lovely stem i also bought the ritchey torque wrench to make sure that it was tightened up right.
Upon tightening up the bolts its slowly started to round the heads in two of them, and rounded to a certain degree where if it was to tighten it anymore then i wouldn't be able to undo it again. And i read on the forum that you had revised the bolts to a t-15 torque head rather than a t-20 3mm Allen key.
Wondering where i can stand on getting some of these torque headed bolts
Regards
Chris Williams
I recently brought a ritchey wcs c260, its a lovely stem i also bought the ritchey torque wrench to make sure that it was tightened up right.
Upon tightening up the bolts its slowly started to round the heads in two of them, and rounded to a certain degree where if it was to tighten it anymore then i wouldn't be able to undo it again. And i read on the forum that you had revised the bolts to a t-15 torque head rather than a t-20 3mm Allen key.
Wondering where i can stand on getting some of these torque headed bolts
Regards
Chris Williams