Road Bike, Cycling Forums banner

Blackburn Delphi 3.0 - cadence issue

1K views 0 replies 1 participant last post by  Solopc 
#1 ·
Hi, just wondering if anyone has experienced this issue and found a solution?

In a nutshell, my display is set to include the cadence while riding. About 3 or so minutes into a ride, the cadence disappears from the display, and I can't get it back, not by cycling the display options, or anything. It has happened on my last 2 rides.

The sensor seems to be on snug, and it is within the documented 1-3mm range for the gap between the sensor and magnet, so I am not sure what it could be?

The computer was installed when I bought the bike a few weeks ago. So when I go in for a tune-up to shore up some cable stretch, I will get them to look at it as well. But I was just curious to see if anyone had this issue with this computer, and if there is something I missed. Worked great for the first 100k or so, then the last 2 35k rides I did, just bonked out after starting the ride.

Thanks!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top