2008 Madone Geometry Numbers???

[Roadrider22]

Does anyone have the geometry numbers for the 2008 Madone Performance Fit frames? I can't find them on the 2008 Madone website. I am interested in putting a deposit on one of the incoming 5.5s but need to know the numbers.

[QUiTSPiNiNArOuND]

Check the site again, www.trekbikes.com/madone , and look at the top right hand corner for something like, "how tall is to tall," the geometry should be listed in there.

[kneejerk]

according to what I have read the "pro fit" Madone is the same as the current geometry, although I haven't seen any numbers yet!

[mtaylor495]

Here is the link. It is under the How tall is too tall link

http://trekroad.typepad.com/photos/u...geometry_2.gif

[footballcat]

those numbers are wrong, or they changed stuff. on a 62cm current madone TT is 59cm, on the new madone TT will be all most 60

[Roadrider22]

Thanks for the link to the geometry table. Just what I needed. I have a line on a proper fitting new 2008 5.5 Madone that I may have in my hand by mid next week.

[kneejerk]

I think the geometry, specifically the virtual top tube length, is confusing because the point at which the seat end measurement is taken seems different than the current Madone. I read that whole speal and I recall reading that the 2007 Madone and the 2008 Pro Fit Madones share the same geometry. The two charts don't totally show that.